The matters needing attention in the operation of cd1 wire rope electric hoist are as follows:
1.The wire ropes on the reel should be arranged neatly. If they are overlapped or slanted, they should be stopped and rearranged. It is strictly forbidden to pull and step on the wire rope with hands or feet during rotation. The wire rope is not allowed to run out, and at least three laps are reserved on the reel.
2.The wire rope is not allowed to be twisted or twisted. If the wire is broken more than 10% within a pitch, it should be replaced.
3. During the operation of electronic wire rope hoist. no one is allowed to cross the wire rope. After the object (object) is lifted, the operator shall not leave the hoist, and the object or cage should be brought to the ground during rest.
4. During operation, the circuit hoisting point position, the hoisting position of the reel machine, and the middle floor are separated by a dedicated person on every second floor, a total of 3 people constitute a command operating system, each person is paired with a downgrade and 1 flashlight, and the command system personnel keep the same as the hoisted object With good visibility, there is a person responsible for the operation of the electric control box of the winch, and the driver and commander cooperate closely and obey the unified command of the signal.
5. When the drum wire rope is entangled, two people must cooperate with it, one of them is operated, and the other is guided by hand outside 5M. It is strictly forbidden to use one person to guide the winding with hands and feet to prevent accidents caused by twisting hands or feet.
6. In case of power failure during operation of 5 ton cd1 type electric hoist, cut off the power immediately.
Precautions exist to reduce unnecessary accidents during operation.
Post time: Aug-06-2021